6 Remove the fuel lines from the car body. 7 Squeeze the clips and detach the fuel supply lines from the fuel filter housing. Use fuel line pliers. Use a crowbar. CLUB.AUTODOC.CO.UK 4–8 Be careful! Fuel may leak from the filter housing and hoses. Replacement: fuel filter – PEUGEOT 208 I Hatchback (CA_, CC_). Tip from AUTODOC experts:6 days ago · FIAT PANDA (169_) 1.2 (169. AXB11, 169. AXB1A) Hatchback Petrol 01/2004 on FWD 8 60 44. Skip to main content. Shop by category. Shop by category. Enter your search
Secure the fuel filter to the fuel lines by doing one of the following: Flare nuts: Hold the nut on the fuel filter with one flare nut wrench. Then, turn the nut on the fuel line (clockwise) with the other wrench. Repeat this step on both sides of the fuel filter. Quick-connect fittings: Push the end of the fuel filter into the quick connect
Where is the idle fuel control valve on a fiat strada 1.6. I believe it has another name Idle Air Control. Most of the time it builds up carbon on the plunger of the IAC or fuel control valve. If the valve is having idle problems then tat's the problem.The valve is located on the side of the throttle body good luck Mike L. l. Page 113 IMPORTANT Only use the adapter E5: Unleaded petrol containing up to supplied with the vehicle as it is 2.7% (m/m) oxygen and with maximum WARNING equipped with a dedicated fuel 5.0% (V/V) ethanol compliant with pre-filter. EN228. 138) Do not bring naked flames or lit E10: Unleaded petrol containing up to Fuel - Vehicle cigarettes near Fiat 500 1.2 8v MY 2009 doesn't have MAF-sensor, only MAP-sensor I think. Step 1. Disconnect battery negative terminal. Secure the disconnected negative terminal from any contact. Step 2. Find the MAP-sensor. It's easy to access without removing the air cleaner. The MAP-sensor locates on the left side of inlet manifold. SvCDM1.